All About AC Repair Daily News

Step-By-Step Guide to Furnace Installation

Mar 16

Did you just recently upgrade to a new furnace? And are you hoping that somehow with Google's help, you can attempt to install it yourself? Well, not so fast.

Furnace installation is a complicated process and is not encouraged to be a DIY project for average homeowners. Saving money on furnace installation in Edmond, OK might seem appealing. Still, furnaces involve many complex components such as gas, electrical, plumbing, and ductwork which need specialized installation equipment and expertise from a qualified HVAC contractor.

Nonetheless, here's a simple step-by-step guide for installing a furnace. And for this example, we've used a forced-air gas furnace installation- a popular furnace choice among homeowners.

Select your furnace and decide where to install it

Choose from a variety of furnace types and models and find a suitable location in your house to get it installed. The choice of space will depend on the type of furnace you purchased and how you plan to use the remaining space around your unit.

Each furnace comes with specific instructions for installation. Thus, the requirements for clearance and ventilation vary in each one. Before furnace installation in Edmond, OK, clear the area of dust and debris.

If you're planning to install the furnace in the basement, make sure to install the unit on blocks at least 4 inches high to protect against flooding. Purchase rubber isolation pads if your furnace does not come with them. They assist in reducing furnace noise.

Now it's time to unpack the new furnace, taking out any loose parts and instructions.

Determine where your duct and drain will run

During the furnace installation in Edmond, OK, you will need to drill a hole into the unit for the return air duct on the bottom or side. Most come pre-marked with the proper size opening. After that, decide which side the condensate drain will run. Set up your furnace, preferably with a slight slope pointing towards the condensate drain exit.

Attach to the ducting system

The furnace unit should then be connected to your home's ducting system once positioned correctly and adequately. Your contractor may recommend using metal foil tape or duct sealant to seal any connections; avoid using duct tape as it will not last.

Connect the vent pipes

You should now connect your furnace's intake and exhaust pipes — again, preferably with a slight slope pointing towards the unit so that any condensation can drain properly.

Hook up the gas supply

Be sure to provide adequate ventilation and shut off, and when finished, check for leaks.

Connect the electrical supply

Typically, two connections on a furnace are a low and line voltage. When performing this step, pay special attention to the polarity. Ensure through the instruction manual that your wiring is configured correctly before turning on your new furnace for the first time.

Attach the condensate drain

Your basement's floor usually has a drain hole to which you connect a hose.

Go over your work

In the final step of furnace installation in Edmond, OK, the unit must be switched on and run through a heating cycle. This is to ensure temperature outputs are following the manufacturer's instructions. Allow about an hour for testing. Additionally, you should ensure the condensate drain is correctly draining and no gas leaks.

Need to Upgrade Your Furnace?

The steps listed above give homeowners a general idea of what to expect during furnace installation in Edmond, OK. There are many complicated steps involved, and your safest and most efficient route is to call your trusted HVAC professionals.

For top-notch heating services in Edmond, OK and surrounding areas, contact Triple Play Home Services to schedule your furnace installation today.